1 Clutch Slip Monitoring for Berstorff Twinscrew Extruder[edit | edit source]
With pressing Enter you will get to menu 1^P, by pressing a second time Enter you see menu 2^P. If you press a 3rd time you are back at the default display - rpm
1.1 Settings[edit | edit source]
To set the parameters for i.e. SP1 do following steps......
- Press Enter to reach menu 1^P
- With ↓ (arrow down) go to menu SP1
- Press Enter (SP1 should be blinking now)
- With ↑ ↓ change the parameters as shown in the table below
- When the parameter is set, keep the Enter button pressed until SP1 stops blinking. If you release the Button before it stopped blinking the parameter is not stored in the controller and you have to re-enter again!
- Continue setting all the parameters as shown in the table below (also in menu 2^P)
| 1^P | ______ | 2^P | _____ |
|---|---|---|---|
| FO1 | 4 | FO2 | 4 |
| CT1 | 20 | CT2 | 600 |
| NC1 | 2 | NC2 | 2 |
| STP | 0 | SP2 | 20 |
| Basic | 2 | DT2 | 0 |
| OPP | 1 | FT2 | 0 |
| DIM | 0 | --- | --- |
| VER | 0 | --- | --- |
| SP1 | 4 | --- | --- |
| DT1 | 0 | --- | --- |
| FT1 | 0 | --- | --- |
