Acoustic Alarm Pfannenberg Horn DS5+DS10

1 Settings for Horn 1[edit | edit source]

For Horn 1 you only need to set DIP 3 to ON (default tones will be used)

Inside there is a red Potentiometer with which you can turn up the volume. Turn to the right side (maximum volume)!

Below in the table you can see which sounds are from the first Horn and which from the second! The lower number is always the first Horn.

For Example:

MDO: -H302 + -H306, -H302 is the first one and -H306 the second one

Pull Roll: -H352 + -H356, -H352 is the first one and -H356 the second one

The Outputs from the second Horn are the most time not in a row. Output 4, Output 6, Output 5!

For Horn 2 you need to program the 2nd and the 3rd tone. Do following steps:

Set DIP 7 to ON (programming active)
Set DIP 3+4 to ON (Sound for Operator Call)
Force outputs 1 + 2 (from the second Horn, this means Output 4 + 5 which you can see in the drawings) together at same time to TRUE for several seconds, then delete force
Set DIP 3+4 to OFF
Set DIP 1+2 to ON (Sound for Pinning Alarm or for Gas-Alarm on BSF-Lines)
Force outputs 1 + 3 (Output from second Horn, 4 + 6) to TRUE for several seconds, then delete force
Set DIP 1+2 to OFF
Set DIP 7 to OFF
Set DIP 4 to ON (Basic Tone -> Start Release)
Set DIP 6 to ON (activate individual sound)

S7 Declaration	Out 1	Out 2	Out 3	Out 4	Out 5	Out 6
	Horn 1			Horn 2
HORN_START_WARNING	True	False	False	False	False	False
HORN_FAULT_APPEARED	True	True	False	False	False	False
HORN_FILMBREAK	True	False	True	False	False	False
HORN_WINDER_AUTOCYCLE	True	True	True	False	False	False
HORN_START_RELEASE	False	False	False	True	False	False
HORN_OPERATOR_CALL	False	False	False	True	True	False
HORN_PINNING_ALARM	False	False	False	True	False	True