1 Description[edit | edit source]
The Festo MS4/6 is a pressure sensor. It is equipped with a digital display and three buttons to set the parameters.
2 Parameter Setting[edit | edit source]
Check all settings and change output to normally closed.
Always switch to the next screen by pressing “Edit”. If you need to return to the status display, hold the “Edit” key for one second.
Template:Image Starting at the status display, press “Edit” to enter the editing mode
Template:Image Unit: bar
Template:Image Switching behaviour: threshold comparator
Template:Image -> Template:Image Setpoint: 4,5 bar
Template:Image -> Template:ImageHysteresis: 0 bar
Template:Image Important:
Press “Up” or “Down” to change output from normally closed to normally open
Template:ImageBack at the status display, a yellow square in the upper left corner of the screen indicates that the output is closed
3 Reset to Factory Settings[edit | edit source]
- In case you have not more than 2 Hands, get a guy to help you a short moment
- Power Off the sensor unit
- Press all 3 switches and keep it like this
- Power on the pressure sensor unit and release the switches
