1 Throttle Valve Settings[edit | edit source]
Turn the Throttle valve to the complete open position (+) for shortest start up time.
2 Trouble Shooting[edit | edit source]
2.1 LED[edit | edit source]
| Green LED | Red LED | Reason |
|---|---|---|
| OFF | OFF | Supply Voltage Off |
| ON for 6 sec. after switch on |
ON for 6 sec. after switch on |
start up sequenz |
| BLINK (1 sec) | OFF | Venting |
| ON | OFF | Run (no fault) |
| 4 x BLINK | BLINK (6x / 8x) | Check Pneumatic Supply or Check Electical Connection |
| 4 x BLINK | BLINK (not 6x or 8x) | Internal Fault |
2.2 Start Up Sequenz[edit | edit source]
Sequenz can start if PIN1 and PIN2 have 24V, and PIN8 is for a short time off
- Green and Red LED are ON
- after about 3 sec inside you hear a "click", even without air supply pressure
- then the air goes through the valve (the first time over the throttle valve)
- Red LED should gone after 6 sec
- Green LED is ON
(see also time diagramm in the manual)
