Revision as of 09:51, 3 June 2025 by hw>Gernot.schachinger@brueckner.com
1 Usable[edit | edit source]
This guide can be used for: Bekomat 12, 13, 14, 16, 21 and all subversion of them.
2 Overview[edit | edit source]
Template:ImageThe Bekomat is a automatic condensate draining unit, which is mounted after the air compressor. The device has only 1 push button and 3 leds, which indicates the system status.
3 Checkup[edit | edit source]
- Check, if the valve between the air supply and the Bekomat is opend.
- Check the power supply, if everything is OK, the "Power" - Led lights.
- Push the "TEST" button for 2 sec to open the valve. Check if it opens. You should hear and see the seperated water.Furthermore check the "Valve" Led on the device.
4 Function Test[edit | edit source]
Close the valve between the air supply and the Bekomat, if it is possible. The Bekomat only has an fault signal to PVSS. To simulate a fault push the "Test" button >1 minute. Now you should see an "Condenser Seperator" fault in PVSS. If you release the push button, the error disapears.
5 Trouble Shooting[edit | edit source]
- If the Bekomat doesn't open the valve to release the water, check the connection between the control unit and the valve. Furthermore check the powersupply again.
- If you don't get a signal to PVSS, check the connection between the error output of the Bekomat and the connection to the input card.
- For more information, check the manual
