Festo MS6 - electrical connection

The original Festo drawing

Modify the connection like this drawing. Take care to modify the connector labels

Description:

Open Plug connector at MS6
Disconnect the wire at Terminal 4 and connect it to Terminal 5
Change Terminal Labels in the Cabinet like in the modified drawing (303 -> 302, ...)
Make sure that the wires from BMS side are connected right
Check that the Terminal 306 and 307 are jumpered (Automatic Start mode of MS6 Valve)
Remove other Jumpers, which are not needed! Festo put sometimes for all 24V, but BMS supply the devices from the IO card.

BMS Drawing