YM:Festo MS6 - electrical connection

Template:Infobox bms

File:Festo MS6 Original Festo Drawings.jpg

The original Festo drawing

File:Festo MS6 Patch Festo Drawings.jpg

Modify the connection like this drawing. Take care to modify the connector labels

Description:

• Open Plug connector at MS6
• Disconnect the wire at Terminal 4 and connect it to Terminal 5
• Change Terminal Labels in the Cabinet like in the modified drawing (303 -> 302, ...)
• Make sure that the wires from BMS side are connected right
• Check that the Terminal 306 and 307 are jumpered (Automatic Start mode of MS6 Valve)
• Remove other Jumpers, which are not needed! Festo put sometimes for all 24V, but BMS supply the devices from the IO card.

File:Festo MS6 Patch BMS Drawing.jpg

BMS Drawing